Mr. Toast has to be the leading expert that I am aware of regards DFI K6BV3+/66 boards. Have problem that needs knowledgeable advice, regards setting of DMA. Does not seem to be taking effect, though it is marked with a check. Everest shows all the DMA channels but 1 as being available, and that one is not being used by a HDD. Also disk read and write speed checking programs show little difference when enabled or not. Additionally would very much like to enable four bank interleave if that is possible with these boards.
Have been unsuccessful thus far. Help!!
Does anybody know how to get a hold of Mr. Toast?
RE: Does anybody know how to get a hold of Mr. Toast?
I can PM you his last known email address, but it's been two years since I've heard from him. He may not use it anymore. Hopefully he won't mind me giving it to you otherwise.
RE: Does anybody know how to get a hold of Mr. Toast?
Well my Email was sent, so I guess the address is still in use. Am awaiting developments.
Superpuppy 3
K6-3+ 450 ACZ (6x100)
DFI K6BV3+/66 Rev B2 (2 Meg) w/ 2x28mm Chipset Fans
2x256 Meg PC 133 Hynix SDRAM
1x 20G Maxtor (7200)
2x 80G Maxtor (7200) Ducted w/ 2x486 Fans Mount
52/24/52/16 LG CDR/RW/DVD
8/4/3/12/24/16/32 LG Super Multi
ATI 9000 aiw Radeon AGP
SB Audigy 1 MP3 Sound
CMD 649 IDE Controller
NEC USB 2 Card
K6-3+ 450 ACZ (6x100)
DFI K6BV3+/66 Rev B2 (2 Meg) w/ 2x28mm Chipset Fans
2x256 Meg PC 133 Hynix SDRAM
1x 20G Maxtor (7200)
2x 80G Maxtor (7200) Ducted w/ 2x486 Fans Mount
52/24/52/16 LG CDR/RW/DVD
8/4/3/12/24/16/32 LG Super Multi
ATI 9000 aiw Radeon AGP
SB Audigy 1 MP3 Sound
CMD 649 IDE Controller
NEC USB 2 Card