Volt mod ASUS TX97-E

Discussion relating to Socket 7 hardware.
Post Reply
User avatar
anomic
Newbie K6'er
Posts: 10
Joined: Wed Nov 21, 2007 4:37 am
Location: Lelystad, The Netherlands
Contact:

Volt mod ASUS TX97-E

Post by anomic »

Hi forum,

I wonder if it is possible to get the vcore below the minimum setting of 2.0 volt. I like to feed my k6-III+ 400 ACZ (1.6V) a little bit less juice than the minimal 2.0V. I found some other stuff for other boards, but not for the TX97-E.

Thanks for the input!

Mike.
User avatar
kalabok
Senior K6'er
Posts: 147
Joined: Mon Nov 06, 2006 11:40 am
Location: germany

Post by kalabok »

mission impossible, unless you want to make a tricky hardware mod.
i have no knowledge concerning this. i guess, kachiwachi can help you in such things.
User avatar
KachiWachi
K6'er Elite
Posts: 507
Joined: Wed Sep 21, 2005 10:53 am
Location: Pennsylvania, USA

Post by KachiWachi »

You would have to map out the VCore circuit to see what it is capable of.

Thanks.
Moderator - Wim's BIOS

PC #1 - DFI 586IPVG, K6-2/+ 450 (Cyrix MII 433), 128 MB EDO. BIOS patched by Jan Steunebrink.
PC #2 - Amptron PM-7900 (M520), i200 non-MMX, 128 MB EDO
PC #3 - HP8766C, PIII-667, 768 MB SDRAM
PC #4 - ASUS P3V4X, PIII-733, 256 MB SDRAM
PC #5 - Gateway 700X, P4-2.0 GHz, 768 MB PC800 RDRAM
PC #6 - COMPAQ Evo N1020v laptop, P4-2.4 GHz, 1 GB PC2700 DDR
PC #7 - Dell Dimension 4600i, P4-2.8 GHz, 512 MB PC2700 DDR
PC #8 - Acer EeePC netbook, Atom N270 @ 1.60 GHz, 1 GB RAM
PC #9 - ??? ;)
Post Reply